 MK220 Electronic Control Pad for steam showers.
This item comes with pre-fitted cable to connect to the steam generator unit via a pinned plug data connection.
Enables control of Steam timer, lights, radio, fan, ozone.
Size: 220mm x 70mm
Fitting hole dimensions: 200mm x 60mm
AquaLusso have produced this useful video guide for replacing the Control Panel
INSTALLATION
Fitting of this item is as simple as removing the 4 fixing bolts holding the pad in place and pushing the pad into the shower cabin from the rear of the shower. Clean the area of any silicone used to provide water protection, apply a new bead of sealant to bed the pad into, place the pad in position, re-fasten the bolts and connect the data lead. Clean up any excess sealant and power the system back up.
UPGRADING YOUR CONTROL PAD
When replacing control pads you MUST replace with the same pad as the connections from the pad can be different to those on the steam generator or electronics.Additionally the data communication to and from the generator must correspond (think of it like pointing a television remote at a different Make/Model of television, the remote would not control the television correctly)
If you wish to upgrade your control pad to a later generation, then you MUST purchase a corresponding steam generator system. This may require modification to the tower panel of your shower to house the control pad that may be a slightly different shape or size.
|
